What's New

Solar Cell Efficiency Leaps 44%

While we are used to seeing incremental advances in solar cell efficiency almost every week, these smaller advances of one or two percentage points have not captured major attention. Now, researchers at the University of New South Waleshave taken a large leap in solar cell efficiency, moving the bar from 24 to 34.5 percent. The solar cell configuration developed by the team sets a new record for unfocused sunlight-to-electricity conversion efficiency, nudging closer to the theoretical limits for such a device.

The record was set by Dr Mark Keevers and Professor Martin Green, Senior Research Fellow and Director, respectively, of UNSW’s Australian Centre for Advanced Photovoltaics, using a 28-cm2 four-junction mini-module – embedded in a prism – that extracts the maximum energy from sunlight. It does this by splitting the incoming rays into four bands, using a hybrid four-junction receiver to squeeze even more electricity from each beam of sunlight.

The new UNSW result, confirmed by the US National Renewable Energy Laboratory, is almost 44% better than the previous record – made by Alta Devices of the USA, which reached 24% efficiency, but over a larger surface area of 800-cm2.

Dr Mark Keevers with one of the spectrum splitting, four-junction mini-modules developed at UNSW. Photo courtesy of University of New South Wales.

Dr Mark Keevers with one of the spectrum splitting, four-junction mini-modules developed at UNSW. Photo courtesy of University of New South Wales.

“This encouraging result shows that there are still advances to come in photovoltaics research to make solar cells even more efficient,” said Keevers. “Extracting more energy from every beam of sunlight is critical to reducing the cost of electricity generated by solar cells as it lowers the investment needed, and delivering payback faster.”

The result was obtained by the same UNSW team that set a world record in 2014, achieving an electricity conversion rate of over 40% by using mirrors to concentrate the light – a technique known as CPV (concentrator photovoltaics) – and then similarly splitting out various wavelengths. The new result, however, was achieved using normal sunlight with no concentrators.

“What’s remarkable is that this level of efficiency had not been expected for many years,” said Green, a pioneer who has led the field for much of his 40 years at UNSW. “A recent study by Germany’s Agora Energiewende think tank set an aggressive target of 35% efficiency by 2050 for a module that uses unconcentrated sunlight, such as the standard ones on family homes.

Australia’s research in photovoltaics has already generated flow-on benefits of more than $8 billion to the country, Green said. Gains in efficiency alone, made possible by UNSW’s PERC cells, are forecast to save $750 million in domestic electricity generation in the next decade. PERC cells were invented at UNSW and are now becoming the commercial standard globally.

The record-setting UNSW mini-module combines a silicon cell on one face of a glass prism, with a triple-junction solar cell on the other. The triple-junction cell targets discrete bands of the incoming sunlight, using a combination of three layers: indium-gallium-phosphide; indium-gallium-arsenide; and germanium. As sunlight passes through each layer, energy is extracted by each junction at its most efficient wavelength, while the unused part of the light passes through to the next layer, and so on.

Diagram courtesy of University of New South Wales.

Diagram courtesy of University of New South Wales.

Some of the infrared band of incoming sunlight, unused by the triple-junction cell, is filtered out and bounced onto the silicon cell, thereby extracting just about all of the energy from each beam of sunlight hitting the mini-module.

The 34.5% result with the 28 cm2 mini-module is already a world record, but scaling it up to a larger 800-cm2 – thereby leaping beyond Alta Devices’ 24% – is well within reach. “There’ll be some marginal loss from interconnection in the scale-up, but we are so far ahead that it’s entirely feasible,” Keevers said. The theoretical limit for such a four-junction device is thought to be 53%, which puts the UNSW result two-thirds of the way there.

Multi-junction solar cells of this type are unlikely to find their way onto the rooftops of homes and offices soon, as they require more effort to manufacture and therefore cost more than standard crystalline silicon cells with a single junction. But the UNSW team is working on new techniques to reduce the manufacturing complexity, and create cheaper multi-junction cells.

However, the spectrum-splitting approach is perfect for solar towers, which use mirrors to concentrate sunlight which is then converted directly into electricity.

The research is supported by $1.4 million grant funding from the Australian Renewable Energy Agency (ARENA). ARENA’s CEO Ivar Frischknecht noted that the UNSW team is working with another ARENA-supported company, RayGen, to explore how the advanced receiver could be rolled out at concentrated solar PV power plants. He also noted that over the longer term, these innovative technologies are also likely to take up less space on our rooftops and in our fields.

Other research partners working with UNSW include Trina Solar, a PV module manufacturer and the U.S. National Renewable Energy Laboratory.

About Tom Breunig (72 Articles)
Tom Breunig is principal at Cleantech Concepts, a market research firm tracking R&D projects in the cleantech sector. He is a technology industry veteran and former international marketing and communications executive who has worked with organizations in semiconductor design, water monitoring, energy efficiency and environmental sensing. He has spoken at numerous technology and energy conferences.
Contact: Twitter

Leave a comment

Your email address will not be published.


*